RX-888 mkII

The RX-888 mkII designed by Justin Peng and Howard Su arrived!
It is an evolution of the first RX888. The curiosity won out and I opened it.

RX-888 mkII

Be careful if you decide to open your device because two heat pads are used to carry the heat from the R828D and the LTC2208 to the aluminium case. I managed to slide them out without damaging them by moving the PCB very gently. A plastic wide stick may help to push out the pads and after to reassemble the radio.

RX-888 mkII: The PCB layout is similar to RX888


In HF the input attenuator is a  PE4312  covering a 31.5 dB attenuation range. This replaces the 0, -10 ,-20 dB attenuator of RX888.

It is followed by the low pass filter at 64 MHz.

Then two switches PE4259  select the HF input or the VHF tuner R828D produced by Rafael Micro that replaces the R820T2. The added transformer connects in a balanced way to the R828D IF outputs.

An AD8370 digitally controlled variable gain amplifier (VGA) provides precision gain control, high IP3, and low noise figure (7 dB).  It replaces the LTC6401-20  20 dB LNA in RX888.

The PCB shows a jumper and a coaxial connector that allows the use of an external reference 27 MHz clock. I have not tested this configuration.

The actual software release supports the RX-888 mkII that is automatically detected.

While testing the development branch of the software I ran both my RX888 and RX-888 mkII units up to 140 MHz of ADC clock at room temperature with no problem.

( by the way the next release will allow to program ADC clock from 50 MHz to 140 MHz )

The greater attenuation and VGA amplifier’s range improve the level range that the receiver is able to manage. Unfortunately I have not professional instruments to make an exact measurement.

In the picture there are few signals higher than 30 MHz as my antenna has a low pass filter at 30 MHz. My unit shows a weak spur near 34 MHz that moves with temperature. I have not yet located the source.

If RX-888 mk2 is the winner as sensitivity and high input level tolerance, it seems to me it has some dB higher  spurs, possibly the AD8370 has a little higher distortion than RX888’s  LTC6401-20.

source: repository of SDR receiver designs by Oscar Steila ik1xpv

Latest RX888 Plus RX-888 MKII verified sale

error: Content is protected !!